Use code BLACKFRIDAY$50 at checkout to save $50 on DJI FPV Batteries!
Purchase a Technical Consultation and Receive a Store Credit Equal to the Value of Your Booking!
Valid 25/11/21 - 3/12/21

Book Now


Add your deal, information or promotional text

BNF FPV | iFlight Evoque F5X | 6S | 5-Inch | Squashed-X | Caddx Polar Vista HD | TBS Crossfire | LED Edition

The iFlight Nazgul F5X Evoque is a large 5-Inch FPV Drone from iFlight, using 5-inch props, and a Squashed-X frame layout for optimised response when flying freestyle.

Designed for racing and freestyle., the Evoque also has upgraded side-panels to keep the dirt and grass away from your internal components, and the XT60 connector is built into frame. Having the XT60 connector externally positioned is safer for the pilot and your props won't cut into your XT60 cable. iFlight's Evoque F5D is built for cinematic flying with your GoPro or Insta360 and available here.

XING2 Performance Motors

7075 aluminum bell, 5mm titanium alloy shaft, NSK durable bearings, Center slotted magnets for better response and lower air gaps for a higher magnetic flux with increased performance and efficiency. The XING damping ring between the bell and bearing to increase durability and smoothen out your flights.

LED Lights

360-degree illumination for day and night.The bottom light indicates battery voltage, a quick check gives you a hint of the voltage still remaining; Never lift off with an empty battery again. Installed LED wires in the side panels and the bottom of the arms are also illuminated.

Digital HD Experience - Caddx Polar

Equipped with the DJI Digital FPV system with 50mBit transmission for 720P video feed on your DJI FPV Goggles. The iFlight Evoque is uses the Caddx Vista Polar HD systemand offers better image quality than other CaddX cameras - better low light performance and more detailed shadows. In daylight the Caddx Polar is similar to the Nebula Pro, with improved dynamic range.

Australian Stock & Free Shipping


  • Side panels to prevent grass and dirt getting into electronics
  • TBS crossfire
  • Caddx polar for night flying
  • LEDs for night flying
  • 6S | 5-Inch for reliable tried and tested build 


  • Total Dimensions: 136*190mm (body dimension)
  • Geometry: Squashed-X frame
  • TBS crossfire
  • Bottom to top distance: 28mm
  • Arm Thickness: 6mm
  • Bottom plate thickness: 3mm
  • Top plate thickness: 3mm
  • Upper(middle) plate thickness: 3mm
  • XING2 2207 1855KV motors
  • Nazgul F5 propellers
  • Weight: 412g (without battery and GoPro mount)


  • MCU: 216MHz STM32F722
  • Gyro:2x ICM20689
  • Blackbox:32MB
  • Betaflight OSD: YES
  • BEC: 5V 2.5A / 9V 2.5A
  • Current sensor scale:  100
  • Inverter for SBUS input (UART2-RX)
  • Smart audio & Tramp VTX protocol supported
  • Beeper pad: Yes
  • RSSI input pad: No
  • UARTs:5
  • Motor outputs: 4
  • 8 pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5)
  • 6 pin DJI Air Unit port (R1, GND, R2, T2, GND, 9V)
  • BLHeli32 Telemetry: Yes
  • Input voltage: recommended 2-6S, MAX 6S
  • Firmware target: IFLIGHT_F722_TWING
  • Mounting pattern: 20*20mm φ3
  • Dimensions: 29*29mm
  • USB Type-C


  • Dimension: 31*29.5mm
  • Mounting Holes: 20*20mm/Φ4mm
  • Weight: 10.8g
  • Supports 2-6S Lipo input
  • MCU: G071
  • Constant: 55 Amps 
  • Burst: 60 Amps
  • Current sensor: Yes
  • BEC: No
  • Current rate: 100
  • Supports DShot DShot150/300/600/MultiShot/ OneShot etc.
  • Firmware: BLHeli 32
  • Target:  iFlight-G071-4IN1

In the Box

  • 1x Nazgul Evoque F5X frame
  • 4x Nazgul F5 Prop
  • 2x Sets of Battery Pads
  • 4x Battery straps
  • 1x Screws bag

Notify me when this product is available:

Search XM2 store